How to Setup GeoIP Block using Apache

Setup GeoIP based blocking using Apache on Ubuntu or Debian. The GeoIP module allows the admin to block or redirect traffic based on location.

In this guide you are going to learn how to install GeoIP module and configure it t block specific countries.

Choose Best Hosting for your Business.

Apache installed and configured. You can check this guide on how to install and configure Apache2.

Install GeoIP module for Apache using the following command.

This command will install the required module for Apache.

There are 2 methods to enable GeoIP. If you wish to enable GeoIP server wide you can follow the method 1. This method will have some performance issues.

You can also enable GeoIP from your virtual host configuration.

Once the module is installed edit the module configuration and make changes as listed below.

...

Read Full Post

News Link: https://www.cloudbooklet.com/how-to-setup-geoip-block-using-apache/?utm_source=rss&utm_medium=rss&utm_campaign=how-to-setup-geoip-block-using-apache.
RSS Link: https://www.cloudbooklet.com/feed/.

Linux Chatter is a news aggregator service that curates some of the best Linux, Cloud, Technical Guides, Hardware and Security news. We display just enough content from the original post to spark your interest. If you like the topic, then click on the 'read full post' button to visit the author's website. Use Linux Chatter to find content from amazing authors!

Note: The content provided has been modified and is not displayed as intended by the author. Any trademarks, copyrights and rights remain with the source.

Disclaimer: Linux Chatter sources content from RSS feeds and personal content submissions. The views and opinions expressed in these articles are those of the authors and do not necessarily reflect those of Linux Chatter.